MANNOL DPF Regenerator & Flush Fluid 1L+1L MN9995 / MN9996
by MANNOL
Original price
€49.78
-
Original price
€49.78
Original price
€49.78
€49.78
-
€49.78
Current price
€49.78
SKU MN9995/MN9996
- DPF Regenerator & Flush Fluid is a professional-grade cleaning solution for diesel particulate filters (DPF) that restores efficiency without dismantling.
- Suitable for all diesel engines, including naturally aspirated and turbocharged models.
- Compatible with vehicles equipped and not equipped with automatic DPF regeneration systems.
- Applied to the particulate filter using a sprayer with a compressor.
- Stage 1 - 9995 DPF Regenerator:
- Initiates regeneration of the particulate filter, promoting complete soot combustion.
- Acts as a combustion catalyst, loosening soot and dissolving unburned dirt from filter pores.
- Especially effective for vehicles used in urban environments and in cold weather.
- Stage 2 - 9996 DPF Flush Fluid:
- Flushes out all dissolved residues left by the 9995 DPF Regenerator.
- Restores full filter capacity, reducing hydrodynamic resistance for improved engine performance.
- Extends DPF lifespan and may eliminate the need for expensive filter replacements.
- Features a neutral, low-ash formula that evaporates completely, leaving no residue.
- Helps restore engine power and improve fuel efficiency.
- Reduces the toxicity of exhaust emissions.
- Stage 1 - Using 9995 DPF Regenerator:
- Turn off the engine and allow the DPF to cool below 40°C.
- Pour the entire product into a spray container.
- Remove a DPF sensor (pressure or temperature).
- Insert the spray gun into the sensor opening.
- Spray the entire contents of 9995 DPF Regenerator at 4 BAR pressure.
- Let the product act for 20 minutes.
- Reinstall the sensor, then run the engine at 3000 RPM for 5 minutes (dirty black liquid may escape from the exhaust).
- Turn off the engine and allow the DPF to cool below 40°C.
- Stage 2 - Using 9996 DPF Flush Fluid:
- Pour the entire 9996 DPF Flush Fluid into a spray container.
- Remove the DPF sensor again.
- Insert the spray gun and spray the entire product at 4 BAR pressure.
- Leave for 1-2 minutes, then reinstall the sensor.
- Run the engine at 2000-2500 RPM for 5-15 minutes until all product has evaporated.
- Foam flakes may escape from the exhaust pipe stopping foam output indicates complete evaporation.
- Post-Cleaning Procedure:
- Drive for 20-30 minutes at 3000 RPM on a flat road, or let the engine idle until it reaches operating temperature.
- For optimal results, start a forced (manual) DPF regeneration, following the vehicle manufacturers guidelines.
- To maintain DPF cleanliness, use 9994 MANNOL DPF Filter Cleaner between service intervals.